Influence of runner section on curing rate during injection molding of NBR compound

Kyas, Kamil; Staněk, Michal; Škrobák, Adam; Maňas, Miroslav; Maňas, David; Řezníček, Martin; Šenkeřík, Vojtěch

dc.title	Influence of runner section on curing rate during injection molding of NBR compound	en
dc.contributor.author	Kyas, Kamil
dc.contributor.author	Staněk, Michal
dc.contributor.author	Škrobák, Adam
dc.contributor.author	Maňas, Miroslav
dc.contributor.author	Maňas, David
dc.contributor.author	Řezníček, Martin
dc.contributor.author	Šenkeřík, Vojtěch
dc.relation.ispartof	International Journal of Mechanics
dc.identifier.issn	1998-4448 Scopus Sources, Sherpa/RoMEO, JCR
dc.date.issued	2013
utb.relation.volume	7
utb.relation.issue	3
dc.citation.spage	242
dc.citation.epage	250
dc.type	article
dc.language.iso	en
dc.publisher	North Atlantic University Union (NAUN)	en
dc.relation.uri	http://www.naun.org/main/NAUN/mechanics/c112002-175.pdf
dc.subject	Cure rate	en
dc.subject	Injection mold	en
dc.subject	Injection molding process	en
dc.subject	Pressure sensor	en
dc.subject	Rubber compound	en
dc.subject	Temperature sensor	en
dc.description.abstract	Right used computational analyses are commonly good tool for technical industry to improve process. This paper show using computational analysis during injection molding process. With using two different shape and two different section dimensions of injection molding channel there is shorted cycle time for product which is represented by 30 mm cube. Results show the save of time for different temperatures of injection mold. These received dates should be helpful for setting of injection machine and cycle in rubber injection molding process.	en
utb.faculty	Faculty of Technology
dc.identifier.uri	http://hdl.handle.net/10563/1003527
utb.identifier.obdid	43870211
utb.identifier.scopus	2-s2.0-84886378255
utb.source	j-scopus
dc.date.accessioned	2013-11-26T13:19:11Z
dc.date.available	2013-11-26T13:19:11Z
utb.contributor.internalauthor	Kyas, Kamil
utb.contributor.internalauthor	Staněk, Michal
utb.contributor.internalauthor	Škrobák, Adam
utb.contributor.internalauthor	Maňas, Miroslav
utb.contributor.internalauthor	Maňas, David
utb.contributor.internalauthor	Řezníček, Martin
utb.contributor.internalauthor	Šenkeřík, Vojtěch
utb.fulltext.affiliation	K. Kyas, M. Stanek, A. Skrobak, M. Manas, D. Manas, M. Reznicek, V. Senkerik
utb.fulltext.dates	-
utb.fulltext.sponsorship	This paper is supported by the internal grant of TBU in Zlin No. IGA/FT/2013/020 funded from the resources of specific university research and by the European Regional Development Fund under the project CEBIA-Tech No. CZ.1.05/2.1.00/03.0089 and Technology Agency of the Czech Republic as a part of the project called TA03010724 AV and EV LED luminaire with a higher degree of protection.
utb.fulltext.faculty	-
utb.fulltext.ou	-