Adaptive predictive control of time-delay systems

Bobál, Vladimír; Kubalčík, Marek; Dostál, Petr; Matějíček, Jakub

dc.title	Adaptive predictive control of time-delay systems	en
dc.contributor.author	Bobál, Vladimír
dc.contributor.author	Kubalčík, Marek
dc.contributor.author	Dostál, Petr
dc.contributor.author	Matějíček, Jakub
dc.relation.ispartof	Nostradamus: Modern Methods of Prediction, Modeling and Analysis of Nonlinear Systems
dc.identifier.issn	2194-5357 Scopus Sources, Sherpa/RoMEO, JCR
dc.identifier.issn	2194-5365 Scopus Sources, Sherpa/RoMEO, JCR
dc.identifier.isbn	978-3-642-33226-5
dc.identifier.isbn	978-3-642-33227-2
dc.date.issued	2013
utb.relation.volume	192
dc.citation.spage	61
dc.citation.epage	72
dc.event.title	Nostradamus Conference
dc.event.location	Ostrava
utb.event.state-en	Czech Republic
utb.event.state-cs	Česká republika
dc.event.sdate	2012-09
dc.event.edate	2012-09
dc.type	conferenceObject
dc.language.iso	en
dc.publisher	Springer-Verlag Berlin	en
dc.identifier.doi	10.1007/978-3-642-33227-2_9
dc.relation.uri	https://link.springer.com/chapter/10.1007/978-3-642-33227-2_9
dc.description.abstract	Design of an optimal controller for higher-order systems often leads to complex control algorithms. One of the possibilities of control of such processes is their approximation by a lower-order model with a time-delay (dead time). These time-delay processes can be effectively handled by model-based predictive control (MPC) method. The paper deals with design of an algorithm for adaptive predictive control of higher-order processes which are approximated by a second-order model of the process with a time-delay. The controller was tested and verified by simulation on experimental data from a laboratory model of a heat exchanger.	en
utb.faculty	Faculty of Applied Informatics
dc.identifier.uri	http://hdl.handle.net/10563/1003135
utb.identifier.obdid	43869240
utb.identifier.scopus	2-s2.0-84874632888
utb.identifier.wok	000313767300009
utb.source	d-wok
dc.date.accessioned	2013-02-24T06:51:46Z
dc.date.available	2013-02-24T06:51:46Z
utb.contributor.internalauthor	Bobál, Vladimír
utb.contributor.internalauthor	Kubalčík, Marek
utb.contributor.internalauthor	Dostál, Petr
utb.contributor.internalauthor	Matějíček, Jakub
utb.fulltext.affiliation	Vladimir Bobal a,b,∗, Marek Kubalcik b, Petr Dostal a,b, Jakub Matejiceka a Centre of Polymer Systems, University Institute, Tomas Bata University in Zlin. Nad Ovcirnou 3685, 760 01 Zlin, Czech Republic b Department of Process Control, Faculty of Applied Informatics, Tomas Bata University in Zlin, Nad Stranemi 4511, 760 01 Zlin, Czech Republic ∗ Corresponding author at: Department of Process Control, Faculty of Applied Informatics, Tomas Bata University in Zlin, Nad Stranemi 4511, 760 01 Zlin, Czech Republic. Tel.: +420 576035197; fax: +420 57603 5279. E-mail addresses: [email protected] (V. Bobal), [email protected] (M. Kubalcik), [email protected] (P. Dostal), [email protected] (J. Matejicek).
utb.fulltext.dates	-
utb.fulltext.sponsorship	This article was created with support of Operational Programme Research and Development for Innovations co-funded by the European Regional Development Fund (ERDF), and the national budget of the Czech Republic within the framework of the Centre of Polymer Systems project (reg. no. CZ.1.05/2.1.00/03.0111).